Use and Care Guide

2. To install and tighten a threaded fastener, push

the torque setting switch to the left so it extends

further out on the left side of the tool. Then turn

the LEFT switch while reading the torque

settings on the RIGHT side of the tool until it

clicks into place at the desired setting: the notch

on the RIGHT side switch will point to the

setting LO, MED or HI. Place the socket over

the threaded fastener on the workpiece, apply

pressure and press the trigger. The tool anvil

(B) will spin clockwise to tighten the treaded

fastener down as shown in Fig 2.

3. To loosen or remove a threaded fastener, push

the torque setting switch to the right so it

extends further out on the right side of the tool.

Then turn the RIGHT switch while reading the

torque settings on the LEFT side of the tool

until it clicks into place at the desired setting:

the notch on the LEFT side switch will point to

the setting LO, MED or HI. Place the socket

over the threaded fastener on the workpiece,

apply pressure and press the trigger. The tool

anvil will spin counterclockwise to loosen the

threaded fastener up as shown in Fig 3.

Always make sure the workpiece is secure. Never run the tool off the workpiece.

Do not apply excessive force to the tool; let the tool perform the work.

NOTE: This tool has a flush-type grease fitting. The tool should be greased generously

following every 48 hours of use. Consult your local retailer for further assistance in

selecting a grease gun and grease to use with this tool.