Use and Care Guide

OPERATING INSTRUCTIONS

1. Pull the knob up from the regulator and turn the knob clockwise until the

required air pressure is obtained.

2. Pull the knob up from the regulator and turn the knob counterclockwise

when you are reducing the air pressure as required. You may hear air

leaking from the regulator. This is normal as this is the air bleeding off.

3. Lock the regulator by pushing the knob down when the required air

pressure is set.

NOTE: To prevent damaging the regulator, make sure that the regulator knob

is unlocked whenever you are adjusting air pressure. The air pressure

readings on the regulator just denote the air pressure from air supply. The

actual air pressure to an operating tool will be lower when the tool starts due

to the fact that a small part of air pressure is distributed through connecting

air hoses. So re-adjust the regulator by following the above Step 1 until the

actual working pressure is obtained to get the best operation of a tool. Then it

is normal that the reading on the regulator will be a little high when a tool is

disconnected from air hose.

PRINTED IN CHINA