KOBE Brand Range Hood CH-177 Models CH7730SQ CH7736SQ CH7742SQ CH7748SQ Professional Style Range Hood INSTALLATION INSTRUCTIONS AND OPERATION MANUAL - READ AND SAVE THESE INSTRUCTIONS - READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING ALL WIRING MUST BE DONE BY A PROFESSIONAL AND ACCORDANCE WITH NATIONAL AND LOCAL ELECTRICAL CODES.
- PLEASE READ THIS SECTION CAREFULLY BEFORE INSTALLATION WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY, OBSERVE THE FOLLOWING: 1) Installation work and electrical wiring must be done by qualified professionals and in accordance with all applicable codes and standards, including fire-rated construction. 2) When cutting or drilling into wall or ceiling, be careful not to damage electrical wiring or other hidden utilities. 3) Ducted fans must always be vented to the outside.
- IMPORTANT SAFETY INSTRUCTIONS - WARNING – TO REDUCE THE RISK OF PERSONAL INJURY IN THE EVENT OF A RANGE TOP GREASE FIRE: Keep fan, optional filter and grease-laden surfaces clean. Always turn hood ON when cooking at high heat. Use high settings on cooking range ONLY when necessary. Heat the oil slowly on low to medium setting. Do not leave cooking range unattended when cooking. Always use cookware and utensils appropriate for the type and amount of food preparing.
- CONTENTS OF RANGE HOOD PACKAGE (Must keep all materials for returns or refunds) 1) 2) 3) 4) 5) 6) 7) KOBE Range Hood Two Impeller Safety Screen Two Round and Two Oval Oil Containers Halogen Lights 12V20W One Plastic Multi Duct Exhaust Base (6” Round, 7” Round or 3¼” x 10” Options) Installation/Owner’s Manual & Warranty Card Packaging Materials May Include: a) Plastic Bag To Cover Hood b) Styrofoam c) Outer carton Unpack hood and check contents before installing.
- PREPARING THE INSTALLATION LOCATION ----SAFETY WARNING---INTERIOR OF HOOD MAY HAVE VERY SHARP EDGES, PLEASE WEAR PROTECTIVE GLOVES IF YOU HAVE TO OPEN THE HOOD FOR CLEANING OR SERVICING. NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING. Make sure the surface of the wall is clean and free of debris. Providing Electrical Power Line Access (SHOULD BE DONE BY A LICENSED PROFESSIONAL) 1.
- INSTALLING THE RANGE HOOD (Keep all packing materials for return or exchange) Temporarily wire the hood to test for proper operation before installing. Before installing, please peel protective film off the hood first, if any. NOTE: The recommended distance from range hood bottom to top of the cooking surface is between 28” ~ 30”. {Fig. 1a} {Fig. 1b} {Fig. 1c} WARNING: As the hood is heavy, we strongly recommend using all 8 mount ing holes to install the hood.
b) For rear venting: Unscrew the rectangular plastic vent portion at the back of the hood. {Fig.4} Turn the vent piece over so that the flat surface is facing you. Cut along the indented outline until there is a 3¼” X 10” opening. Fasten plastic vent piece with the raised surface facing outward back onto the hood. {Fig.4} ( Rear Venting ) {Fig.5} {Fig.6} 5) Remove bottom panel & carefully place aside. 6) Take the hood, place electrical power line through access opening {Fig.
3) Follow installation instructions from the section For Mounting on a Cabinet with a Flush Bottom. Making The Electrical Connection (SHOULD BE DONE BY A LICENSED PROFESSIONAL) ----SAFETY WARNING---INTERIOR OF HOOD MAY HAVE VERY SHARP EDGES, PLEASE WEAR PROTECTIVE GLOVES IF YOU HAVE TO OPEN THE HOOD FOR CLEANING OR SERVICING. CAUTION: MAKE SURE ELECTRICAL POWER IS TURNED OFF BEFORE STARTING THIS SECTION.
- OPERATING INSTRUCTIONS This KOBE hood is equipped with a 10-second time delay operation, four control buttons located on the front of the hood, powerful centrifugal turbine impellers with safety screen covers, bright 12 volt 20 watts halogen lights, and 4 oil containers. The four control buttons (from left to right) are the Light Control, the Speed Control (cycles through Low, Medium, High, QuietMode), alternate Speed Control (cycles through Low, QuietMode, High, Medium) and the Power Control buttons.
- MAINTENANCE OF THE HOOD - ----SAFETY WARNING---INTERIOR OF HOOD MAY HAVE VERY SHARP EDGES, PLEASE WEAR PROTECTIVE GLOVES IF YOU HAVE TO OPEN THE HOOD FOR CLEANING OR SERVICING. Cleaning To clean the hood surface, use only mild soap or detergent solutions. Dry up surfaces using soft cloth. CAUTION: Never use abrasive cleaners, pads, or cloths.
Changing the Light Bulb 1) Make sure all control switches are off and range hood is unplugged. CAUTION: Wait until light is cool to the touch before changing. 2) Use a flat head screwdriver to pop out the protective covering. 3) Gently pull out the defective halogen light and discard. Plug in new halogen light (12V 20W max.). 4) Replace protective cover. 5) Plug in range hood. Keyhole 12V20W Troubleshooting Guide Problem Solution Light does not turn on. Check power is plugged in.
- CIRCUIT DIAGRAM CH-177 Models 11
- PARTS - 12
- PARTS LIST - 1 Plastic Multi Duct Exhaust Attachment 22 Light Transformer Support Screw 2 Plastic Vent Cover 23 Light Transformer Support 3 Plastic Rear Vent Cover 24 Transformer 4 Plastic Vent Cover Screw 25 Control Support Screw 5 Rear Plastic Vent Cover Frame 26 Control Support 6 Hood Casing 27 Control Panel 7 Motor Chamber 28 Control Board 8 Motor 29 Capacitor 9 Turbine Impeller 30 Processor Board Box 10 Oil Tunnel Ring 31 Processor Board 11 Oil Tunnel 32 Round Head Sc
- SPECIFICATION STYLE Size Dimension (WxDxH) Net Weight (lbs) Features: Stainless Steel #304 Fan Type Control Button Halogen Light (12 Volts) Duct Free* Safety Screen Oil Container CH-177 MODELS 36” 42” 30” 48” 30” x 22” x 9” 36” x 22” x 9” 42” x 22” x 9” 48” x 22” x 9” 48.5 50.6 52.
DISCLAIMER 1) CAREFULLY INSPECT ALL ITEMS FOR DAMAGES BEFORE ACCEPTING DELIVERY. NOTE ANY DAMAGES ON THE FREIGHT BILL OR EXPRESS RECEIPT, REQUEST SIGNATURE OF THE CARRIER’S AGENT AND KEEP COPY TO SUPPORT YOUR CLAIM. Upon acceptance by the carrier, he/she assumes responsibility for its safe arrival. Damages should be reported to carrier and a claim filed. Failure to do this could result in the carrier refusing to honor your claim. The carrier will furnish you with necessary forms for filing a claim.
WARRANTY CERTIFICATE KOBE Range Hoods warrants all products manufactured or supplied by it to be free from defects in workmanship and materials. Its obligations pursuant to this warranty are limited to a period of two years from the date of purchase and to the repair or replacement at its option and subject to the terms and conditions stated below, of any component part, which its examination shall disclose to be so defective.
CONSEQUENTIAL DAMAGE The warrantor is not responsible for any consequential damage. SOME STATES DO NOT ALLOW THE EXCLUSION OF CONSEQUENTIAL DAMAGE SO THE ABOVE EXCLUSION MAY NOT APPLY TO YOU. IMPLIED WARRANTIES/STATE LAW Any implied warranties, including the implied warranty of merchantability and fitness for purpose, imposed on the sale by the laws of the state of sale are limited to two years from the date of original purchase. Some states do not allow limitations on the duration of implied warranties.
