KOBE Brand Range Hood Model No.
- READ AND SAVE THESE INSTRUCTIONS - CONTENTS Important Safety Instructions................................................................................................. 1 Components of Package....................................................................................................... 3 Installation............................................................................................................................. 4 Operation Instructions..............................................
IMPORTANT SAFETY INSTRUCTIONS - PLEASE READ THIS SECTION CAREFULLY BEFORE INSTALLATION - WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY, OBSERVE THE FOLLOWING: 1) Installation and electrical wiring must be done by qualified professionals and in accordance with all applicable codes and standards, including fire-rated construction. 2) When cutting or drilling into wall or ceiling, be careful not to damage electrical wiring or other hidden utilities.
What to Do In The Event Of a Range Top Grease Fire SMOTHER FLAMES with a close fitting lid, cookie sheet, or metal tray, and then turn off the burner. KEEP FLAMMABLE OR COMBUSTIBLE MATERIAL AWAY FROM FLAMES. If the flames do not go out immediately, EVACUATE THE AREA AND CALL THE FIRE DEPARTMENT or 911. NEVER PICK UP A BURNING PAN – You May Get Burned. DO NOT USE WATER, including wet dishcloths or towels – a violent steam blast will result.
COMPONENTS OF PACKAGE (M u s t k e e p a ll m a te ria l fo r re tu rn s o r re fu n d s ) BOX 1 OF 2 Item No. RA-9436 BOX 2 OF 2 REQUIRED ONE OF THESE ITEM: Item No. BF-9436 (Model No. RA9436SQB) KOBE Range Hood – 1 Warranty Registration Card – 1 Instructions Manual – 1 Hood-Mounting Bracket – 2 Screws Package – 1 Baffle Filter – 3 Baffle Handle – 3 Screws Package – 1 Item No. AF-9436 (Model No.
INSTALLATION PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING Calculation before Installation To calculate the length of the installation, please refer to Table 1. (All calculations are measured in inches.
Figure 1 Preparation before Installation NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING. Decide the location of the venting pipe from the hood to the outside. (Figure 1) A straight, short venting run will allow the hood to perform more efficiently. Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the hood. Temporarily wire the hood to test for proper operation before installing.
4. Secure and tighten the mounting screws. CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE RELEASING. Figure 5 Ductwork Installation 5. 6. 7. Using Reference E from Table 1 and measurements on Page 11, mark the leveling point for duct cover-mounting bracket. Secure the duct cover-mounting bracket to the wall with two screws (not provided). (Figure 6) Make sure all screws are tightened. NOTE: Inner duct cover will cover the duct cover-mounting bracket.
inner duct cover with two (4x8 mm) screws (provided). 12. Fasten outer duct cover to plastic plate on the hood with four (4x8 mm) screws (provided). Figure 9 Install Accessories 13. Place aluminum/baffle filters underneath the hood. Refer to Figure 10. Final Assembly 14. 15. Turn power ON in control panel. Check all lights and fan operation. Leave this Installation Instructions and Operation Manual for the homeowner.
OPERATION INSTRUCTIONS This KOBE hood is equipped with four electronic controls with a 10-second standby startup & 30second delay shutoff, one powerful centrifugal squirrel with baffle or aluminum filters, and two bright 12volt 20-watt halogen lights. The four electronic controls are Light Control, Speed Control A, Speed Control B and the Power Control (On/Off). Refer to Figure 11.
MAINTENANCE For the optimal level of operation, clean the range hood surface and filters regularly. To Clean Hood Surface CAUTION: NEVER USE ABRASIVE CLEANERS, PADS, OR CLOTHS. Regular care will help preserve your KOBE Range Hood’s fine appearance. 1. Use only mild soap or detergent. Dry surface using a soft cloth. 2. If hood looks splotchy (stainless steel hood), use an orange base cleaner to clean the surface of the hood. Avoid getting cleaner on the control switches.
SPECIFICATIONS MODEL / SIZE RA9436SQF / 36" (RA-9436 + AF-9436) RA9436SQB / 36” (RA-9436 + BF-9436) COLOR # 304 Commercial Grade Stainless Steel CONSUMPTION / AMPERE 215W / 1.
MEASUREMENTS & DIAGRAMS Front View Bottom View 11
PARTS LIST MODEL NO.: NO.
MODEL NO.: RA9436SQF RA9436SQB Complete Set: Model No. RA9436SQF – Required RA-9436 & AF-9436 Model No.
CIRCUIT DIAGRAM MODEL NO.
DISCLAIMER 1. CAREFULLY INSPECT ALL ITEMS FOR DAMAGES BEFORE ACCEPTING DELIVERY. NOTE ANY DAMAGES ON THE FREIGHT BILL OR EXPRESS RECEIPT. REQUEST NAME AND SIGNATURE OF THE CARRIER’S AGENT AND KEEP COPY TO SUPPORT YOUR CLAIM. Upon acceptance of items, owner assumes responsibility for its safe arrival. Report damages to the carrier and file a claim immediately. Failure to do so may result in the denial of your claim. The carrier will furnish you with necessary forms for filing a claim.
WARRANTY WARRANTY CERTIFICATE KOBE Range Hoods, Inc. warrants all products manufactured or supplied by it to be free from defects in workmanship and materials. Its obligations pursuant to this warranty are limited to a period of two years from the date of purchase and to the repair or replacement at its option and subject to the terms and conditions stated below, of any component, which its examination shall disclose to be so defective.
5) Damages caused during shipment are not covered under our warranty. CONSEQUENTIAL DAMAGE The warrantor is not responsible for any consequential damage. UNLESS YOU LIVE IN A STATE THAT DOES NOT ALLOW THE EXCLUSION OF CONSEQUENTIAL DAMAGE. IMPLIED WARRANTIES/STATE LAW Any implied warranties, including the implied warranty of merchantability and fitness for purpose, imposed on the sale by the laws of the state of sale are limited to two year from the date of original purchase.
PRODUCT REGISTRATION Register Your Product! Any covered failure occurring within two years of original purchase arising from defective workmanship or material in manufacture will be repaired or at our option, replaced free of charge by an authorized KOBE Range Hoods Agent or KOBE Range Hoods as applicable. Keep proof of purchase (original invoice) handy for inspection.
