Owners Manual

7
3. Using references on Table 1 and measurements
on Page 16, center the hood in place beneath the
cabinet and flush with the front of the cabinet.
4. Draw electrical wires through cabinet access
opening.
5. Use electrical drill to remove the knockout holes
on top of the range hood.
6. Place screws (provided) into the exact center of
each knockout hole. Make sure all screws are in
place before tightening screws.
CAUTION: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Figure 4
Wiring to Power Supply
CAUTION: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. RISE OF ELECTRICAL SHOCK.
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE
WITH ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL CODES. BEFORE CONNECTING
PANEL AND LOCK SERVICE PANEL TO
PROVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
7. If hood is operating normally, connect three wires
(black, white and green) to house wires and cap
with wire connectors.
8. Store wires in the wiring box.
Ductwork Installation
9. Use steel pipe to connect the exhaust on the hood
to the ductwork. Use duct tape to make all joints
secure and air tight.
Install Accessories
10. Place baffle filters and spacers underneath the
hood. (Figure 4)
Final Installation
11. Turn power ON in control panel. Check all lights
and fan operation.
12. Make sure to leave this manual for the
homeowner.