Manual

10
4. For Rear 3-1/4” x 10” vent installation only:
- Remove attached 6” exhaust and discard. (Figure
11) Keep 13 screws to install vent cover.
- Remove duct knockout from back of the hood and
discard. (Figure 13) Unscrew 3-1/4” x 10” Vent
Cover from rear exhaust (located inside hood);
keep screws to install 3-1/4” x 10” exhaust.
- Align Top Vent Cover {D} and 3-1/4” x 10” Vent
Cover (removed from rear exhaust) using 14
screws (13 screws taken from 6” exhaust). (Figure
13) Follow instructions in Step 5 to attach Hood-
Mounting Bracket {P} and two Duct Cover Support
{O} using 14 screws (13 screws taken from 6”
exhaust). (Figure 15)
- Attach 3-1/4” x 10” Exhaust {E} to rear exhaust
(located inside hood) using 10 screws taken from
rear vent cover. (Figure 14)
Hood Installation
CAUTION: If moving the cooking range is
necessary to install the hood, turn off the
power in an electric range at the main electrical
box. SHUT OFF THE GAS BEFORE MOVING A
GAS RANGE. And use a protective covering to
protect cooptop and/or countertop from
damage.
5. Secure Hood-Mounting Bracket {P} and two Duct
Cover Support {O} on top of the hood with eight
pre-attached screws. Use four 3/16” x 3/8” screws
{M} for Hood-Mounting Bracket {P}. (Figure 15)
6. Using references on Table 2 and measurements
on page 16-17, mark the leaving point of the hood.
Position mounting screws (provided) on the wall,
leaving 1/8” away from the wall as shown in Figure
16.
7. Align Hood-Mounting Bracket {P} to the two
screws on the wall and hook hood into place.
Thighten screws to secure hood to the wall.
CAUTION: MAKE SURE HOOD IS SECURE
BEFORE RELEASING.
Figure 13
Figure 14
Figure 15
Figure 16
Mounting Screws