KOBE Brand Range Hood Model No.
IMPORTANT READ THIS FIRST READ BEFORE INSTALLATION 1. Carefully check all contents of packages. 2. Thoroughly inspect the unit for any shipping damages, cosmetic damages or defects. 3. Have a certified contractor/electrician test the unit before installation. IF THERE IS ANY PROBLEM: 1. DO NOT INSTALL THE UNIT AND KEEP ALL ORIGINAL PACKAGING MATERIAL. 2. Have your original invoice as proof of purchase and product serial number ready. 3.
[ENGLISH] - READ AND SAVE THESE INSTRUCTIONS - CONTENTS IMPORTANT SAFETY INSTRUCTIONS .................................................................................... 1 COMPONENTS OF PACKAGE.................................................................................................. 3 INSTALLATION .......................................................................................................................... 4 OPERATING INSTRUCTION ........................................................
IMPORTANT SAFETY INSTRUCTIONS - PLEASE READ THIS SECTION CAREFULLY BEFORE INSTALLATION - WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY, OBSERVE THE FOLLOWING: 1) Installation and electrical wiring must be done by qualified professionals and in accordance with all applicable codes and standards, including fire-rated construction. 2) When cutting or drilling into wall or ceiling, be careful not to damage electrical wiring or other hidden utilities.
What to Do In The Event Of a Range Top Grease Fire • • • • SMOTHER FLAMES with a tight fitting lid, cookie sheet, or metal tray, and then turn off the burner. KEEP FLAMMABLE OR COMBUSTIBLE MATERIAL AWAY FROM FLAMES. If the flames do not go out immediately, EVACUATE THE AREA AND CALL THE FIRE DEPARTMENT or 911. NEVER PICK UP A BURNING PAN – You May Get Burned. DO NOT USE WATER, including wet dishcloths or towels – a violent steam blast will result.
COMPONENTS OF PACKAGE (Must keep all material for returns or refunds) Range Hood Box (Box 1 of 2) {A} {B} {A} KOBE Range Hood {B} Baffle Filters {C} Warranty Registration Card {D} Mounting Template {E} Quick Reference Guide Pre-installed {C} {D} {E} Duct Cover Box (Box 2 of 2) {F} Telescopic Stack {G} Two-Piece Duct Cover {H} Screw Package {F} {G} {H} - FOR MORE INFORMATION, PLEASE VISIT OUR W EBSITE www.koberangehoods.com OR CONTACT KOBE RANGE HOODS AT (626) 775-8880.
INSTALLATION PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING Calculation before Installation To calculate installation, please refer to TABLE 1. (All calculation in inches.
Figure 2 Preparation before Installation NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING. - Decide the location of the venting pipe from the hood to the outside. Refer to Figure 1. - A straight, short venting run will allow the hood to perform more efficiently. - Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the hood. - Use duct tape to seal the joints between pipe sections. Telescopic Stack Installation 1.
Figure 5 Duct Cover Installation 6. Slide the inner duct cover up and secure with four (4x8mm) screws (provided) to the upper telescopic stack. Refer to Figure 5. Hood Installation 7. Slide outer duct cover up and place 4 temporary screws to hold the duct cover. Refer to Figure 6. 8. Install the hood using eight (3/16 x 3/8mm) screws (provided) to secure hood to telescopic stack. Make sure to tighten screws securely. Refer to Figure 7.
Finally Assembly Figure 8 13. Remove the temporary screws that hold the outer duct cover up and slide the duct cover downward and secure it to the telescopic stack. NOTE: Be careful when using electrical screwdriver, damage to the hood may occur. Secure the duct cover to hood with four (4x8mm) screws (provided) as shown in Figure 8. 14. Turn power ON in control panel. Check all lights and fan operation. 15. Make sure to leave this manual for the homeowner.
OPERATING INSTRUCTION Note: For best results, turn fan on prior to any preparation or cooking and keep fans running while cooking. Adjust speed as needed. Power Control Press Power Control to turn On/Off the range hood. Speed Control The fan will start on Speed #3. Press increase the speed level. button to decrease the speed level.Press button to To activate 3-minute delay shutoff, press and hold button.
ECO Mode Control ECO Mode is set to turn fan on QuietMode™ setting for 10 minutes every hour to remove excess moisture, microscopic particles and odors for better kitchen air quality. ECO Mode is independent from the Power Control and delay shutoff. ECO Mode can be activated while fan is running or off. Press and hold button until icon briefly appears in the LED Display. While fan is running you can change the speed, use delay shutoff or turn off fan without disabling ECO Mode.
MAINTENANCE For optimal performance, clean the range hood surface and baffles regularly. To Clean Hood Surface CAUTION: NEVER USE ABRASIVE CLEANERS, PADS, OR CLOTHS. *** Regular care will help preserve its fine appearance. 1. Use only mild soap or detergent solutions. Dry surfaces using soft cloth. 2. If hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the hood. Avoid getting cleaning solution onto or into the control panel.
SPECIFICATIONS MODEL / SIZE For 36” model IS2336SQB-DC16-1 IS2336SQB-DC23-1 IS2336SQB-DC59-1 COLOR Commercial Grade Stainless Steel VOLTAGE 120V 60Hz NUMBER OF MOTORS 2 DESIGN 18-Gauge Seamless FAN TYPE Twin Vertical Turbine Impeller EXHAUST Round 6” Round CONTROLS 6-Speed Electronic Button Control with LED Display LIGHTS 3-Level Lighting 4 x LED Lights (3W) HOOD DIMENSION (W x D x H) IS2336SQB-DC16-1 / IS2336SQB-DC23-1 / IS2336SQB-DC59-1 35-3/4” x 27” x 7” For 42” model IS2342SQB-DC16-1
MEASUREMENTS & DIAGRAMS All measurements in ( ) are millimeters. All inch measurements are converted from millimeters. Inch measurements are estimated. Duct Cover MODEL NO. A B DCH C D TSH IS23DC-16-1 (Included in IS23 SQB-DC16-1) IS23DC-23-1 (Included in IS23 SQB-DC23-1) IS23DC-59-1 (Included in IS23 SQB-59-1) 9-1/4” (235) 8-1/4” (210) 17-1/2” (445) - - 16” (405) MAX. HT.
PARTS LIST MODEL NO.: For 36” model IS2336SQB-DC16-1 IS2336SQB-DC23-1 IS2336SQB-DC59-1 For 42” model IS2342SQB-DC16-1 IS2342SQB-DC23-1 IS2342SQB-DC59-1 BOX 1of 2 NO. DESCRIPTION MODEL /SIZE PART NO.
MODEL NO.
CIRCUIT DIAGRAM MODEL NO.
TROUBLE SHOOTING Issue After Installation, both motors and lights are not working. Lights are working, but motor(s) is not. The range hood is vibrating. The motor is working, but the lights are not working. Possible Cause The power is not on. The wire connection is not secure. The control panel and processor board wiring are disconnected. The control panel and processor board is defective. The motor(s) is defective. The capacitor(s) is defective. The control panel or processor board is defective.
WARRANTY WARRANTY CERTIFICATE KOBE Range Hoods (referred to herein as “we”or “us”) warrants to the original purchaser (referred to herein as “you” or “your”) all products manufactured or supplied by us to be free from defect in workmanship and materials as follows: TWO-YEAR LIMITED WARRANTY FOR PARTS AND LABOR ON KOBE PREMIUM/BRILLIA SERIES: For two years from the date of your original invoice from a KOBE authorized dealer, we will, at our sole discretion, choose to repair or replace the product free of ch
If we determine that the warranty exclusions listed above apply or if you fail to provide all necessary documentation for warranty service, you will be responsible for all expenses associated with the requested service, including parts, labor, shipping, travelling and any other expense related to the service request. To qualify for warranty service, you must: 1. Have the ORIGINAL proof of purchase 2. Be the ORIGINAL purchaser of the product 3. Have the model number 4. Have the serial number 5.
WARRANTY INFORMATION FORM Fill in the blanks and keep this paper with the original invoice in a safe place for future service purpose. 1. Date of purchase : 2. Model No. : 3. Serial No. : For warranty service or spare parts purchase contact: KOBE Service Center (USA ONLY) Toll Free: 1-855-800-KOBE (5623) Email: kobe@adcoservice.com For service in Canada and to report a problem, please contact: Phone: 1-626-775-8880 Email: customer.service@koberangehoods.
KOBE Range Hoods 11775 Clark Street Arcadia, CA 91006 USA www.koberangehoods.com This KOBE hood is made for use in the USA and CANADA only. We do not recommend using this hood overseas as the power supply may not be compatible and may violate the electrical code of that country. Using a KOBE hood overseas is at your own risk and will void your warranty. Cette hotte KOBE est fabriquée pour usage aux États-Unis et au Canada seulement.
