Owners Manual

9
Duct Cover Installation
16. Use reference E from TABLE 2 and measurements on
page XX to mark the position of the duct cover-mounting
bracket.
17. Secure the duct cover-mounting bracket to the wall with
two 4*35 screws. Make sure all screws are tightened.
Refer to Figure 3. NOTE: Inner duct cover will cover the
duct cover-mounting bracket.
18. Put the entire duct cover onto the hood and slide the inner
duct cover until it reaches to the duct cover-mounting
bracket.
19. Secure inner duct cover with two 4*8 screws to the duct
cover-mounting bracket. Shown in Figure 4.
Electrical Wire
20. Connect the range hood to an outlet.
21. If hardware is desired, cut off the plug and connect three
wires (black, white, and green) to the outlet wires and cap
with wire connectors. Connect the wires according to color
(ex. black to black).
Finish
22. Remove any protective film from the hood, if any.
23. Before using, make sure that any accessories such as
baffle filters are properly installed where applicable.
24. Test the range hood to see if it is working properly.
THIS RANGE HOOD MUST BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL CODES. BEFORE CONNECTING WIRES, SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
*Note: Sample image only. May not be actual
model.
Figure 3
*Note: Sample image only. May not be actual
model.
Figure 4