User's Manual

Basic function:

1. Receive a call

2. Reject a call

3. Volume adjust

4. Redial the last phone number

User Manual:

Pairing mode for your headset

1. Press and hold the power button (approximately 7-10 seconds) until the blue LED light is

continuously on. (It will flash a few times before it's continuously on).

Paring with your PlayStation 3 System

1. From the system home menu, go to “Settings” then “Accessory Settings”.

2. Select "Manage Bluetooth Devices" option to register or pair the Bluetooth headset with your PlaySt

ation 3 system.

3. If no Bluetooth device is paired with your system, you will see the message "There are no Bluetooth

device registered. Do you want to register?" on the screen. In this case, please select "Yes" and press

the X button to continue with the pairing process.

4. If a Bluetooth device has been paired with your system, a list of all the Bluetooth devices will appear

. You will need to select "Register New Device" and press the X button to pair a new Bluetooth device.

Note : Only one Bluetooth headset can be paired to the system at a time. You must unregister the

previous headset from the system first before pairing a new headset.

5. After you have selected to register a device, you will see the message "To register, you will need to

prepare the Bluetooth device" on the screen. This means that the system will scan for any Bluetooth

devices that is within range. Make sure the Bluetooth headset is set to pairing mode in order for the

system to locate it.

Please refer to the section "Pairing Mode For Your Bluetooth Headset".

6. Once you’ve prepared the Bluetooth headset to pairing mode, you can press the X button to start

scanning.

7. After the scan is completed, your system will list all the devices found within range. Choose the

“HIP STREET” Bluetooth headset and the press the X button to continue. (If no device is found, then it

is likely you have not correctly prepared the headset to be "paired").

8. Once you have selected the “HIP STREET” headset to be paired, you will need to enter the headset’s

pass key to complete the pairing process. Please press the X button to begin entering the pass Key. The

pas key is 4 zeros (0000). You can use the on-screen keyboard to enter the pass key. After you have

entered the correct key, you can move the cursor onto the green Enter button and press the X button to

confirm.

9. After the pass key is entered, you should see it in the center of the screen. Use the D-pad to highlight

OK, and press the X button.

PAGE 1
Basic function: 1. Receive a call 2. Reject a call 3. Volume adjust 4. Redial the last phone number User Manual: Pairing mode for your headset 1. Press and hold the power button (approximately 7-10 seconds) until the blue LED light is continuously on. (It will flash a few times before it's continuously on). Paring with your PlayStation 3 System 1. From the system home menu, go to “Settings” then “Accessory Settings”. 2.
PAGE 2
10. You’ll see the message “Register Completed” on the screen when completed. 11. You have successfully paired your Bluetooth headset. Press the X button to continue and exit. Setting your Bluetooth headset as an Input/ Output Device After the Bluetooth headset has been successfully registered or “paired” with your Playstation 3 system , you must set it as the default “Input / Output Audio Device” before it can be used. 1.
PAGE 3
FCC Information FCC ID：：YH5HSPS3BT This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation. Federal Communications Commission (FCC) Statement This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.