User's Manual

10. You’ll see the message “Register Completed” on the screen when completed.
11. You have successfully paired your Bluetooth headset. Press the X button to continue and exit.
Setting your Bluetooth headset as an Input/ Output Device
After the Bluetooth headset has been successfully registered or “paired” with your Playstation 3 system
, you must set it as the default “Input / Output Audio Device” before it can be used.
1. From the home menu, go to “Settings” and then “Accessory Settings” followed by “Audio Device
Settings”.
2. Select “Input Device” and press the X button. This is where you select the microphone for voice chat
. Scroll up and down until you find your headset and press the X button. The “Output Device” will auto
matically change to match the selected “Input Device”. This setting will allow you to hear other players
' voice chat messages on the Bluetooth headset. Once the input and output device has been selected, yo
u can test the headset’s input/output levels by speaking into the headset. You should be able to hear you
r voice over the selected output device.
If your voice is too soft or low, you can select “Microphone Level” and press the X button to adjust the
volume. When you have completed adjusting the “Audio Device Settings”, select “OK” and press the
X button to return to the home menu.
Turn off and on your headset
1. To turn off the headset, press and hold the power button (approximately 3 – 5 seconds). The blue
LED light will turn on, turn off and remain off.
2. To turn on the headset, press and hold the power button (approximately 3 – 5 seconds). When the
blue light turns on, release the power button.Note : When the headset is in standby mode, the blue LED
light will quickly flash once every 5– 7 seconds.
Mute Function
1. Press and hold the “Vol-“ and “Vol+” simultaneously for approximately 3 seconds. You will hear a
beep and the headset is in mute mode.
2. To take the headset off the mute function, press the “Vol-“ and “Vol+” simultaneously.
Note: The mute function will only mute the microphone. You will still be able to listen.
Using your headset with other Bluetooth enabled devices
This headset can also be used with other Bluetooth enabled devices, such as cell phones. Please refer to
your user manual for such devices for instructions on pairing the headset. To set the headset to the pair
ing mode, please refer to the section "Pairing Mode For Your Bluetooth Headset". The pass key will
remain the same with 4 zeros (0000).
Receiving a call
1. Once the headset is paired and connected to your cell phone, press the “Telephone Call” button to
receive a call. You will not only hear your cell phone ring, but a beep through the headset.
2. Press the “Telephone Call” button once to disconnect the call. Press twice quickly to reject.