Scanner User Manual

B-2 A-61371 September 2004
NOTE: To change any of the system settings described above, contact
your Kodak Service Representative.
System Setting Selection Default Description
Machine ID Printing
(Printer mode only)
Disabled
Pattern 1
Pattern 2
Disabled When two scanners are connected to one printer, this
function leaves an identification marker on the print so
the scanner used for the job can be determined after
printing.
Cycle Print mode
(Printer mode only)
Enabled
Disabled
Disabled This function automatically scans the next image
following a preset period of time (the period can be set
by your Kodak Service Representative). Images are
set by the user onto the carrier glass in between
cycles.
Paper Size of Paper
Feeding tray (Printer mode
only)
Letter / A4
portrait
Letter / A4
landscape
Legal / A3
Legal / B4
B5 portrait
B5 landscape
Letter / A4
portrait
Determines the desired paper size from the Paper
Feeding tray of the printer. It is possible to feed the
following paper sizes and orientations into the printer:
Inch values: Letter-portrait, Letter-landscape, Legal,
Ledger
Metric values: A4-portrait, A4-landscape, A3, B4, B5-
portrait, B5-landscape
Contrast setting Lighter
Normal
Darker
Normal To view subtle images with standard ranges of density
clearly: Light (-1 to -7). To bring out the darker and
lighter ranges of an image: Dark (+1 to +7).
The print function at the
time of Toner Empty
detection (PR mode only)
Disable Print
Enable Print
Disable Print After a Toner Empty condition is detected, this function
allows you to select either to stop printing or continue
printing.
Auto Film Format Select
Print function (PR mode
only)
Enable
Disable
Disable The Auto Format Select Print function is enabled or
disabled through the control panel.
90 degree rotation setting Enable
Disable
Disable Enables the prism to rotate the screen image 90
degrees.
Automatic paper source
switching
Auto switching
Disable Auto
switching
Auto
switching
Allows you to specify the paper source when same
size paper is loaded into both the paper feeding tray
and paper feeding cassette.
Auto switching: Printing continues by automatically
switching to the remaining paper source after paper in
the specified paper source runs out.
Disabling Auto switching: A Paper Empty mode
occurs and printing stops after paper in the specified
paper source runs out. The paper source must be
refilled or the paper source must be switched by
pressing the Output Selection key in order to resume
printing.
Pattern 1
Paper
Pattern 2
Paper