User manual

Focus the Camera-Rotate the Lens Mount-
Selector Ring combination until the figure repre -
senting the camera-to-subject distance in feet
(between 5 and 25) is opposite the focus index.
Be careful not to depress the selector ring lock
while focusing.
NOTE : The focusing scale controls lens openings. Distance
limits at which scale can be set are determined by the flash
guide number.
Aim the Camera-look through the viewfinder
and compose the picture within the luminous view-
frame of the viewfinder. The flash symbol should
appear in the base of the view-frame-if not,
check the setting of the selector ring.
NOTE : Disregard the possible appearance of Ihe low lighl
sienal with nash pictures .
Release the Sh utter -Hold the camera steady and
press the shutter release down with a slow, squeez-
ing action to take the picture. If film has not been
advanced, or if film leader has not been wound
off fully, you cannot make an exposure.
NOTE : The most pleasing appearance of the subject's eyes
will result when the flash picture is taken in a brightly
lighted room, and the subject is not looking directly at the
camera.
Advance the Film-Swing out the rapid wind
lever one full stroke, or several short ones, until it
locks; then let the lever return to its original posi-
tion. Advancing film rotates the Flashcube one
quarter turn for the next flash shol After the 20th
or 36th exposure and before opening the camera,
the film must be rewound into the magazine. See
Unloading, page 8.