Operating Instructions

ManualsBrandsKodak ManualsCamcorderKodak Cine Kodak Special II

10

8

Pass

the

film in

front

of

the

pressure

plate as follows:

Pu

ll

back

the pressure

plate;

then

exert

additional

pressure

on

it

to

make

certain

that

the

PULLDqWN

is free

of

the

film

channel

. (See

the

note

under

step

9

if

th

e film

chamber

is detached.) Slide

the

film into

the film

channel

and

between the STUD

and

the

front

of the

camera.

The

film

must

be all the way in the

channel

so

that

the film pe

rforations

are

engaged

by

the pulldown. Release

th

e

pressure

plate.

note:

Th

e pressure plate

must

be seated entirely with

in

the

film channel

and

properly engaged

with

the

PIN.

See

illustra-

tion.

9 Observe

the

film in the film

channel

and

press

th

e exposu

re

button

for

an

instant;

then

release it.

If

the film

is

correctly

threaded,

the

pulldown will

draw

the film

through

th

e film channel.

If

it

is incor-

rectly

thread

ed, the film will

unwind

from

the

s

uppl

y

spool

and

will pile

up

without

going

through

the

film

channe

l.

When

the

film is

properly

threaded,

take

hold

of

the loose

end

of film

and

hold

in

the

exposure

button

until

about

an ad

ditional foot

and

a half of film is

run

off

the

supply spool.

note:

If

the film chamber is not attached to the mechanism

part of the camera, insert the film into

the

film channel as

follows:

Rotat

e the

SPROCKET

until the

pulldown

is clear

of

the film

channel;

then

open the pressure plate

and

slide the film into

the channel.

Turn

the sprocket counterclockwise a few times

so

that the

pulldown

draws the film through the channel.

It

may

be necessary to move the film in the channel slightly until

the

pulldown

engages

th

e perforations. The sprocket

must

turn

easily

and

the

pulldown

must

draw

the

film through

the

channel.

10

Follow

the

thr

eading

guide line between

the

pressure

plate

and

th

e lower

guide;

then

thread

the

film be-

tween the sprocket

and

the lower sprocket clamp.

Engage

the film

perforations

with

th

e sprocket te

eth;

then close

th

e clamp to

hold

the

film

in

position.

11 Locate

the

TENSION

LEVER

to

the

left of

the

stud

marked

with

the

size of the spool used.