Operating Instructions

LOADING
the 100-foot film chamber
The 100-foot film chamber is supplied with a 100-foot
and a 50-foot Cine-Kodak Film Spool. Save these
spools
and use them for tak e-up spools when you load
the camera . A short strip of film is provided to prac-
tice threading.
note: If the motor is run down, turn the motor crank a few
turns before threading the film chamber.
1 Turn the DOOR LOCK one-half turn counterclockwise
and push it toward OPEN; then swing open the door.
2 Push the BOSS of the tension lever toward the
SPROCKET until it locks; then remove the take-up
spool
from the take-up spindle.
3 Push in the CLAMP RELEASE and open the sprocket
clamp.
4 Unroll
about one foot of film and fit the square hole
in the spool of film over the square base on the sup-
PLY SPINDLE. (If the film chamber is off the mecha-
nism part, unroll about two feet of film.)