Operation Manual

5-8 A-61555 April 2009
11. Manually rotate and wipe the feed module tires with a roller cleaning
pad. For best results wipe parallel to the ribs in order to remove any
residue between the ribs.
12.Inspect the tires. If the tires show signs of wear or damage, replace
the feed module tires. See “Replacement procedures” later in this
chapter.
13.Reinstall the feed module by aligning the pins and fitting it into
position. Pull up on the release lever to lock it into place. Verify that
the feed module is securely in place and moves freely after you
install it.
14.Close the printer access cover.
Align
these
areas