User Manual
59
Standard Housing-C: For use with other accessories when waterprooing is not required
Installation Method:
1. Hold the bottom of the locking arm and lip up to open it.
2
1
2. Open the locking arm of the standard housing and place the camera inside
housing as shown in diagram below. Press the top cover of the ixed mount
around camera to close it. Press the bottom of the lock as shown in diagram
below until locked into place.
4. Use the included accessories tool to fully tighten the setscrew. Be careful not
to over tighten screw and risk stripping.
Accessories Tool
3. Install the housing mount on the desired accessory and use the
setscrew to tighten.
In order to prevent deformation or damage of the Standard Housing
accessory, please refer to the diagram to the left for your reference and do
not overtighten screws.
Use the protection latch only at the time of transportation and storage.
Keep the latch in such a way that it does not detach when mounting.
Protection
latch