Instruction manual

4-8 A-61601 June 2010
6. Select Image Cleaner Tool if you want the scanner to attempt to
eliminate any streaks in the image after scanning.
7. Click Settings if you want to change any of the default scan settings
(i.e., mode, resolution, sharpen images, etc.).
NOTE: You can change the settings anytime before starting a
Batch or Flatbed scan.
8. Click Batch Scan or Flatbed Scan. The message Scanner lamps
are warming may be displayed. Scanning will start when the lamps
are ready (usually within a few seconds).
NOTES:
• If you are using an optional Kodak A4 Flatbed or Kodak A3
Flatbed, the photo must always be placed face down on the
platen.
• When Batch Scan is selected, you have 1 to 20 seconds to
place photos into the Picture Saver System Scanner depending
on the transport timeout value.
As photos are being scanned, the scanned images will be displayed
1-up in the Scan Viewer screen.
Pause the Scan Viewer display to look for streaks, double-feeds,
etc. The scanner will not stop. To stop the scanner, pull the rest of
the photos out of the feeder.