User Manual
6
1. Delate the screen. Then clean the damaged area, allowing it to dry thoroughly.
2. Cut out a portion of the patch to the desired size, rounding the corners as illustrated.
3. Remove the adhesive backing from the patch, then position the patch over the damaged area.
4. Smooth out any bubbles so that the patch lays lat.
5. Allow the patch to sit for at least 30 minutes before inlating the screen.
• Always unplug the air pump before performing maintenance.
• Periodically examine the air pump for potentially unsafe conditions such as a damaged cord, plug,
housing, or parts. If damage is found, do not use the product until it has been properly repaired by a
qualiied professional.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or
similarly qualiied persons in order to avoid a hazard.
• The air pump does not require any lubrication and has no user serviceable parts. Do not attempt to
service the air pump.
• Clean with a damp cloth. Do not immerse the air pump in water.
• Regularly check the intake and output openings and keep free of dirt, leaves, etc.
• When not in use, store the air pump indoors in a dry place.
• Store the air pump upright on a stable surface.
• Loosely coil the cord and place it beside the air pump.
Should you experience any problems with your product, please contact us before returning the item to
the place of purchase. We’re here to help!
U.S. Support: kodak@camarketing.com, 8445161539
International Support: kodakintl@camarketing.com, 8445161540
6B. USING THE REPAIR PATCHES
6C. AIR PUMP MAINTENANCE
7. CUSTOMER SERVICE