User Manual

35
Repeat the above setup for each camera.
Press and hold the
and buttons on the remote control at the same time until pairing is successful.
While pairing, the remote control shall be closer to the camera.
For the successfully paired cameras, it is recommended to remove the battery (it will disconnect unless you reset the camera or shut it down in the "Remote
Off" interface, otherwise it will not disconnect) to prevent the successfully paired camera from malfunctioning during the pairing process.
2. Set the desired shooting mode (movie mode or snap shot photo mode ) and the display mode (Globel or Front ).
Other parameters are set the same as the current settings of the camera at the same mode.
3.. Press the button on the remote control to start shooting or recording, and press the button again to stop recording.
4. To terminate remote control, just press the button on the "Remote Off" interface.