User Manual

36
When appears on the interface,
indicates that the camera is out of control of the remote control at the moment.
indicates that the remote control is under the control of one camera at the moment.
indicates that one remote control controls multiple cameras at this time.
It indicates that the camera has been set at this channel.
In case of successful pairing between the camera and the remote control (the camera is capable of memorizing the remote control paired
successfully last time):
1. If the camera is powered off, the camera is powered on and start recording by pressing the button on the remote control.
2. The camera is powered on or whether the remote control is paired successfully is tested by pressing the button. The camera will be powered off by pressing and
holding the button (more than 1.5 seconds).
3. When the button on the remote control is pressed to start recording or shooting, the camera works with the current setting of the remote control.
If the camera has been powered off for more than 6 hours, it is impossible to power on the camera directly with remote control.
Indicator lamp status description:
1. If pairing succeeds, the signal indicator lamp turns green.
2. If pairing fails, the signal indicator lamp turns red.
3. During remotely controlled recording or shooting, the shooting status indicator lamp turns orange. When using "Multi Control", the shooting status indicator lamp will not
illuminate.
4. When the battery level of the camera is less than 25% or the memory card is full, the battery/memory card indicator lamp turns red.