Installation Instructions

Remove the shield cover located on the astern side. (There are four fixing screws.)

Remove the cable clamping plate and rubber ring, pass cable through the introduc-

tion opening, put the rubber ring from both ends of it, and clamp the cable to the

scanner unit with screws via the fixing plate. Connect 7-pin connector to X11 and

9-pin connector to X12 of PCB.

Replace the aluminum cover. At this time, attach a cable shield onto a ditch with

the aluminum cover. However, be careful that the cable will not be caught up be-

tween the main unit and cover.

Replace the upper part of the radome. Be careful not to bump it against the an-

tenna in the same way as when removing it. Make sure that the cover is fitted in the

correct direction as shown in Fig.3-7-2. The upper and lower parts of the radome

each have four markings indicating screw positions. Align the upper and lower po-

sitions as you mount the radome.

Ship's

heading

Logo seal on

side wall

Fix four screws

Cable inlet

Fig.3-7-2 Fitting cover (RA41C)