User Manual

72
5.5.4.5.3 Changing the content of settings 2 (PRESET2)
Refer to the section, “Changing the content of setting 1(PRESET1)”.
a) Guard Zone Level Guard Zone Detection Level setting
1: High Sensitivity, .. 7: Large Target Only
b) Guard Zone Mode Guard Zone Detection Mode setting
IN: To detect entry of a target
OUT: To detect leaving of a target
c) Hold To hold the radar picture presentation for 30 seconds after
switching to ST'BY
The EBL and VRM can be used in HOLD state.(Note1: )
d) Display Unit Mode Display Unit Operation Mode setting
RDR: Radar mode (normal)
MONI: Monitor mode (for slave display use)
NAV: Navigation mode (for DATA indicator use)
e) External Buzzer External Buzzer control setting
OFF: Buzzer off
CONT: Continuous tone
INT: Intermittent tone
f) Bearing pulse/rot.(IN) Change the setting when connected to the other type of radar
g) Bearing pulse/rot.(OUT) Change the setting when connected to the other type of radar
h) Built-in simulator To display stored radar picture for presentaion purposes.
i) Interference Rejection Reject the interference from other radar transmissions
OFF: IR OFF
IR1: ON level 1
IR2: ON level 2
a) Guard Zone Level
b) Guard Zone Mode
c) Hold
d) Display Unit Mode
e) External Buzzer
f) Bearing pulse/rot(IN)
g) Bearing pulse/rot(OUT)
h) Built-in Simulator
i) Interference Rejection
j) Ship's Speed
k) Indication Language
l) Scan speed
m) Color
PRESET2
GZ LVL 1 2 3 4 5 6 7
GZ MODE I N OUT
HOLD ON OFF
DISPLAY RDR MONI NAVI
EXT BUZ OFF CONT INT
IN P /R 1080 1024 2048 4096 360
OUT P/R 1080 1024 2048 4096 360
DEMO ON OFF
IR OFF IR1 IR2
SPD SET NMEA MANU 0.0KT LOG 200P
LANGUAGE CHI DAN ENG FRE GER
GRE ITA JPN KOR NOR
POR RUS SPA SWE TUR
SCAN SPEED STD HIGH
COLOR MONO MULTI
PRESS ENTER KEY TO RETURN