User Manual

50
5.5.1.7 Erasing heading marker temporarily (HDG OFF)
(1) Use the up-down cursor key to select HDG OFF
from the pulled down menu.
(2) Press the “ENT” key to turn off the heading marker,
it stays off as long as you press and hold the key.
Up/Down → ENT The heading marker is off as long as you press and hold the “ENT” key down.
(Select HDG OFF)
5.5.1.8 Using parallel cursor (///CSR)
Using the parallel cursor, you can monitor the behavior of other targets whether they are navigating
along with the course or, changing their course to someway.
(1) Use the up-down cursor key to select ///CSR from the
pull-down menu, and press the “ENT” key (ON/OFF
display beside the ///CSR item).
(2) Use the up-down cursor key to select ON.
(3) Press the “ENT” key. Parallel cursor will appear on the
screen. As you move EBL, the parallel cursor also
moves.
To cancel the ///CSR function, select OFF in (2).
Up/Down → ENT → Up/Down (Select ON) → ENT ----------------Parallel cursor appears.
(Select ///CSR)
→
Up/Down (Select OFF) → ENT ------------ Parallel cursor disappears.
Note: Interval of ///CSR same as fixed range marker.
///CSR moves with EBL1.
.75
.25
HU
Not displayed while the ENT key
is held down.
.75
.25
HU
2 20.3°
FL EBL2
SET START POINT
.75
.25
HU
Origin of EBL2
To measure the angle between two
points
indication of
EBL2
small cross mark
cross mark
.75
.25
HU
EBL1
Parallel cursor