User Manual

23
ƒ Remove the two bolts securing the transceiver; pull out the transceiver after removing two con-
nectors.(to Motor(J5), to Heading switch (J3) )
„ Remove the four bolts securing the fixing plate at the cable entrance.
… Remove the metal fixing plate, rubber seal and washer that secure the cable. Pass the cable
through as shown in the diagram below; replace the above items and tighten the bolts.
† Return the transceiver to its original position and secure it with the removed bolts.
‡ Connect 7-pin connector to J2 and 9-pin connector to J1 of PCB. And connect two connectors that
were removed at ƒ.
ˆ Refit the scanner covers.
Take care not to pinch the cable when refitting the cover.
Fig.3-9 Interconnecting cable