Instruction Manual

24 RA51/52/53/54/55 INSTRUCTION MANUAL – 05
4.2 Rear panel____________________________________________
•
Power supply connector
The wires in the cable that attaches to this connector supply both power and NMEA interface
data. Refer to Section 3.7.4 “ Power Cables “ and Section 3.9 “Connecting External
Equipment to Display Unit “.
‚
Grounding terminal
Use this terminal to connect grounding wire. Refer to Section 3.7.3 “Grounding wire”.
ƒ
Option connector
Connect an NMEA data source, an external monitor, external buzzer or GYRO I/F here
through an optional connector or using a junction box. Refer to Section 3.9 “Connecting
External Equipment to Display Unit”.
„
Scanner connector
This connector is for the cable that runs between the display and the scanner.
Refer to 3.7 “Connecting cable “.
4.3 Radar screen (Single screen) ____________________________
Ship’s position
EBL2
VRM2
Indicate soft key
3
1
HU L
1:58
+
RADAR OFF
EBL1
VRM1
EBL2
VRM2
FL EBL2
FL VRM2
NEXT
A
HOLD
ZOOM
OFF-C
LAT/LON
35°08.42N
139°02.53E
2 129.8°
2 12.34NM
0.23NM
HDG
129.0 °T
SPD
12.0 KT
G 59
S AT
F AT
ST1
GZ IN
TK 15 S
WP
134.4
°
12.5NM
+LAT/LON
35°08.42N
139°02.53E
1 129.8°
1 12.3NM
Tune meter
Picture hold
Zoom
Off-center
Range
Range ring interval
Display mode
Heading angle
Cruising speed
Enlarging echo
Guard zone
Track
Way point
EBL1
VRM1
Pulse width
Course error
Gain
STC
FTC
Cross cursor
Cross cursor position
(LAT/LON or Distance/Bearing)