User's Manual

MDC-2000A Series Chapter 2 How to use the menu
00931200007-01 2-10
shows the positions of own ship and other ships
after one minute.
Setup: 0 to 60min (Initial value: 1min)
1 Press the [MENU] key.
2 Select [DISPLAY] → [VECTOR].
3 Change the setting of [VECTOR] with the
[
] and [ ] keys.
4 Press the [MENU] key to close the menu.
The bearing mode of the vector line is
specified in [DISPLAY] → [VECTOR
TRUE/REL].
2.17 Alarm
This mode is used when monitoring targets.
When targets enter in the set range or exit from
the set range, the buzzer notifies.
Two types [IN] and [OUT] are provided for the
alarm mode.
IN Mode
When a target enters within the specified range,
the alarm is issued.
This mode is used when watching targets which
are approaching to own ship.
OUT Mode
When a target exits from the specified range, the
alarm is issued.
Setting of Alarm Range
1
Press the [MENU] key.
2 Select [ALARM] → [ALARM MODE].
3 Change the setting of [ALARM MODE] with
the [
] and [ ] keys.
ALARM MODE
IN
OUT
OFF
4 After selecting [IN] or [OUT], press the [ ]
key. Then, the alarm range can be set.
5 Move the crosshair cursor to the center of
the alarm range with the [
], [ ], [ ] and [ ]
keys.
6 Press the [ENT] key.
7 Change the distance direction with the [ ]
and [
] keys and the bearing with the [ ]
and [
] keys.
8 Press the [ENT] key. Then, the alarm range
is set.
9 Press the [MENU] key to close the menu.
The level of targets for alarm is set in [ALARM]
→ [DETECT LEVEL].
The alarm works when detecting the level higher
than the set level.
When [DETECT COUNT] is set, the alarm works
depending on the [ALARM MODE] setting.
[IN Mode]: The alarm works when targets enter
continuously into alarm area more than
[DETECT COUNT] value.
[OUT Mode]: The alarm works when targets
leave continuously from alarm area more than
[DETECT COUNT] value.
2.18 Sleep
The power OFF state and the transmitting state
are alternately repeated. This mode saves the
power consumption.
The sleep is used in combination with the
IN/OUT alarm.
For the setting of the alarm, refer to 2.17
Alarm.
Setup: OFF, 5MIN, 10MIN, 15MIN, (Initial value:
OFF)
1 Press the [MENU] key.
2 Select [ALARM] → [SLEEP].
3 Change the setting of [SLEEP] with the [ ]
and [
] keys.
4 Press the [MENU] key to close the menu.