User's Manual

Chapter 2 How to use the menu MDC-2000A Series
0093120007-01
2-13
Manual Acquisition
Direct to acquire a target by designating a target
on the display.
1 Press the [MENU] key.
2 Select [ATA] → [ACQ].
3 Press the [ ] key.
4 Align the crosshair cursor with a target you
desire to acquire with the [
], [ ], [ ] and
[
] keys.
5 Press the [ENT] key. Then, the acquisition of
the designated target is started.
6 When acquiring several targets, repeat
steps 4 and 5.
7 Press the [MENU] key to close the menu.
Target Level
The signal level of a target to be
automatic/manual-acquisition is specified in
[ATA] → [ATA TGT LEVEL].
By increasing the numeral, a strongly reflected
target can be acquired.
By decreasing the numeral, a weakly reflected
target can be also acquired.
Target Delete
Release the acquisition of a target.
1 Press the [MENU] key.
2 Select [ATA] → [DELETE].
3 Press the [ ] key.
4 Change the setting of [DELETE] with the [ ]
and [
] keys.
DELETE
CURSOR
NUMBER
5 After selecting [NUMBER] or [CURSOR],
press the [
] key. Then, the number
designation or the cursor designation can be
set.
6 ● In case of [MAN ACQ NUM], change the
number to be deleted with the [
] and
[
] keys.
● In case of [CURSOR], align the crosshair
cursor with the target you desire to delete
with the [
], [ ], [ ] and [ ] keys.
7 Press the [ENT] key. Then, the acquisition of
the designated target is released.
8 When releasing acquisition of several
targets, repeat steps 6 and 7.
9 Press the [MENU] key to close the menu.
To release acquisition of all targets, execute
[ATA] → [ALL DELETE].
Number of Acquisition
A total number of targets to be acquired is 50
targets when combined in both
automatic/manual methods.
The number specified in [ATA] → [MAN ACQ
NUM] becomes a number of targets to be
manually acquired. And the rest becomes a
number of targets to be automatically acquired.
1 Press the [MENU] key.
2 Select [ATA] → [MAN ACQ NUM].
3 Change the setting of [MAN ACQ NUM] with
the [
] and [ ] keys.
4 Press the [MENU] key to close the menu.
Information Display
The information display is set in [ATA] → [INFO]
or [INFO NUMBER].
The target information of the designated number
is displayed at the bottom of the display.
1 Press the [MENU] key.
2 Select [ATA] → [INFO].
3 Change the setting with the [ ] and [ ]
keys.
4 Select [ATA] → [INFO NUMBER].
5 Select the number with the [ ] and [ ] keys.
6 Press the [MENU] key to close the menu.
ATA Performance
The ATA performance is set in [ATA] →
[PERFORMANCE].
This is to select the optimum tracking
characteristics (calculation process) depending
on the purpose of usage, to make the best of the
ATA performance.
Select the most suitable setting to the behavior of
own ship or target.
Setup: 0 to 7 (Initial value: 0)