User's Manual

MDC-2000A Series Chapter 5 Equipment
0093120007-01 5-11
Caution: When installing on the desktop, the maintenance space shown in the illustration
below is required for cable lay-out, plugging-in/out of connector, fuse replacement and
bolt tightening.
Flush-mount Installation
(1) Make a square hole (308mm x 308mm) at the location to be installed.
(2) Turn counterclockwise the knob bolt fixing the Display unit to the mounting bracket to loosen it,
remove the Display unit from the bracket. The mounting bracket and knob bolt are no longer used.
(3) Remove four plastic screw covers, which are fitted on each corner of the display front face.
(4) Confirm that the unit matches with the square holes. If not matched, correct the square hole.
(5) Connect all of the connectors for power, Antenna and others to the main unit.
(6) Install the Display unit in the installing location (square hole) and fix it with four 4mm tapping
screws (or M4 pan-head screw). (Prepare 4mm screws suitable for thickness of installing
location.)
(7) Refit the coverings removed in step (3).
Unit: mm (inch)
Display unit
Corner guard cap (4pcs)
M4 screw (4pcs)