User's Manual

Chapter 7 System and Maintenance menu operation MDC-7000P/7900P Series
0093169006-05E 7-8
7.10 System Program
Version confirmation
Currently installed firmware version can be found by using following menu operation.
Note: This menu is protected in normal. To cancel the protection, refer to 1.3 Menu usage “Display
[MAINTENANCE] menu”.
1 Press MENU key to display “Menu”.
Select [MAINTENANCE] => [VERSION] =>
MRD/MRM-108P
KM-F44 xx.xx Firmware version of Display/Processor unit
MRO-108P
KM-F45 yy.yy Firmware version of Operation unit
How to update the system program
1 Prepare SD memory card with latest program.
File name: radar
File type: MOT
2 Turn off the power.
3 Insert SD memory card in the upper card reader on the rear of the Display unit.
4 Press POWER ON/OFF key to turn on, radar will start update procedure automatically.
Message of “LOADING IN PROGRESS”, “PLEASE DO NOT POWER OFF” etc., and time bar will
be displayed.
During updating, EBL1 and VRM1, EBL2 and VRM2, BRILL and PANEL key’s lamps flash red.
Few minutes later, when program update is complete, “LOADING COMPLETE” and “PLEASE
EJECT SD CARD” messages will appear on the display.
5 Remove SD memory card from the card reader, and new system program will run automatically.
The list of updated program file will be shown on the display.
In some cases, message of “SHUTDOWN” is displayed, and power will be turned off.
In this case, please press POWER ON/OFF key again, and message of “INITIALIZING” will be
displayed.