User's Manual

MDC-7000P/7900P Series Chapter 1 Display and Operation
0093169006-05E 1-11
Note: About the shaded menu:
[INTER-SWITCH] in [SYSTEM] menu, and [SECTOR MUTE], [BACKUP], [TOTAL HOUR] and [TX
HOUR] in [MAINTENANCE] menu are not available during transmission, therefore they are greyed
out.
Note: [MAINTENANCE] is protected menu and it is normally not displayed.
Display [MAINTENANCE] menu
1 Press MENU key to display “Menu”.
Select [SYSTEM] => [PROTECT MENU] => [ON], and press ENT key after selection.
2 [PROTECT MENU xxxx] => turn trackball to right, [Set password (xxxx)], and press ENT key after
setting.
Initial password value (xxxx): (0000).
Menu display disappears once after a correct password is input. Press MENU key once again to use
“Menu”.
How to change PASSWORD
After [PROTECT MENU] => [ON], select [MAINTENANCE] => [PASSWORD] =>
[New PASSWORD input], and press ENT key.
Selection values: 0000 to 9999
Note: The new password is active after a restart.
1.4 Cursor Access usage
Basic radar functions can be operated by using trackball and ENT key without using menu.
This function is effective for the operation with USB Mouse/Trackball from the remote place.
Move cursor on a grey item with trackball, then press ENT key.