User's Manual

Chapter 2 Radar Basic Operation MDC-7000P/7900P Series
0093169006-05E 2-24
Using the EBL OFFSET
EBL base point can be changed to any position other than the initial reference point.
By changing the base point, the bearing from a random target can be measured.
1 Display the EBL for which the base point is required to be changed.
2 Move the cursor to new position.
3 Press EBL knob, and the base point of EBL changes.
During offset, the color of [OFFSET lamp] at the lower right of EBL knob changes from green to red,
and the “TM” or “RM” mark is added right of the numerical figures.
“TM” means true motion, and “RM” means relative motion of OFFSET EBL1 and EBL2.
The motion selection can be changed by [NAV TOOL] => [EBL] => [EBL1 OFFSET] or [EBL2
OFFSET] => select [RM] or [TM], and press ENT key.
4 Press EBL knob again, and the base point returns to the reference point.
Note: The base point for VRM cannot be changed.
Reference
point
EBL1
CURSOR
Push
EBL knob
Press
OFFSET
OFFSET EBL true or relative motion mark
Reference
point
CURSOR
EBL1