User's Manual

MDC-7000P/7900P Series Chapter 2 Radar Basic Operation
0093169006-05E 2-27
PI
000.0°
3.000NM
PI RE L PI
000.0°
3.000NM
PI RE L
HALF
FULL
4 Turning EBL knob changes the bearing of a selected line.
Note: Turning EBL knob (while pressing it) changes the bearing quickly.
ClockwiseCounter
clockwise
EBL knob
PI 1/4
000.0°
3.000NM
PI RE L 1/4
5 To return all PI lines to original position, press OFF key following by a quick press of VRM knob
while holding the OFF key. Make sure that the VRM knob press is followed immediately after
pressing the OFF key.
6 By following procedure user can turn any one of 7 lines ON or OFF and change its needed.
Press MENU key to display “Menu”.
Select [NAV TOOL] => [PI] => [LINE]
LINE => LINE: Lets user choose line number (1-7) and its parameters.
LINE => DISP: Lets user turn selected line ON or OFF.
LINE => START RNG: Lets user choose starting position of selected line.
(-96.0 – 96.0 NM)
LINE => END RNG: Lets user choose ending position of selected line.
(-96.0 – 96.0 NM)
PI DISP SIDE: Select HALF or FULL
MODE: Select CURSOR or LINE
CURSOR: If mode is set to CURSOR available selections are NORMAL, 1, 2, 3, 4, 5, 6 or 7
PI UNIT: Select NM, km or RANGE LINK
(RANGE LINK sets PI Units to same units used for range)
PI OPERATION: Select BULK or INDIVIDUAL
(When BULK is selected all PI lines are operated together by VRM and EBL knobs.)
(When INDIVIDUAL is selected PI lines are operated one by one in sequence by
pressing VRM knob)