User's Manual

MDC-5200/5500 Series Chapter 6 Map operation

0093155002-03 6-3

6.4 COAST LINE

This function is to let user generate up to 10 coast lines with up to 100 points each to mark important

areas of navigation, such as danger zone areas or navigation channels etc. Coast line can be setup by

inputting Lat/Lon information for each point or using cursor and ENT key.

It is displayed one by one or all.

1 Press MENU key to display “Menu”.

Select [MAP] => [COAST LINE] =>

COAST LINE: Select the number of the coast line to display. (ALL, 1 to 10, OFF)

ALL: Display all ten coast line.

1 to 10: Display the coast line of selected number.

OFF: Don’t display coast line.

EDIT: Create coast line. (CURSOR, BLOCK NUMBER)

MOVE: Change the position. (CURSOR, BLOCK NUMBER)

ADD: Insert a position data. (CURSOR, BLOCK NUMBER)

DELETE: Delete a position data. (CURSOR, BLOCK NUMBER)

CLEAR: Clear a selected block number coast line data.

How to edit

(1) CURSOR OPERATION

1 Press MENU key to display “Menu”.

Select [MAP] => [COAST LINE] => [EDIT] => [CURSOR] => select [1 to 10] => [GO] and press

ENT key.

2 Move cursor to first input position, then press ENT key. No.1 mark is displayed on the display and

numerical data is shown at “COAST LINE INFO” window.

3 Move cursor to second input position, then press ENT key. No.2 mark is displayed, and a line is

generated from No.1 to No.2.

Edit of LAT/LON data, color setting

and delete function can be operated

directly

using cursor with trackball/joystick in

this info window.

x-1

x-2

x-1