User's Manual

MDC-5200/5500 Series Chapter 2 Radar Basic Operation
0093155002-03 2-27
(For MDC-5200 series)
Note: To use PI function, perform the following setting.
[NAV TOOL] => [EBL2/VRM2 KEY] => select [PI], and press ENT key.
1 Press EBL2 or VRM2 key, and PI lines are displayed.
Bearing is displayed by figure on middle lower left of the display, and distance between PI lines is
displayed on middle lower right of the display during PI is displayed.
2 Press EBL2 key and turn the EBL/VRM knob to change the bearing
when symbol with PI bearing value.
3 Press VRM2 key and turn the EBL/VRM knob to change the interval between lines
when symbol with PI distance value.
4 Press EBL2 or VRM2 key displayed symbol, PI lines and values are not displayed.
PI bearing value PI distance value
PI bearing value
PI distance value