User's Manual

MDC-5200/5500 Series Chapter 2 Radar Basic Operation
0093155002-03 2-29
(For MDC-5200 series)
Note: If to use ERBL function, perform the following setting.
[NAV TOOL] => [EBL2/VRM2 KEY] => select [ERBL], and press ENT key.
1 Press EBL2 or VRM2 key and ERBL is displayed.
2 By moving cursor to target A, measurement of bearing from target A to target B can be obtained by
using EBL/VRM knob, and measurement of distance from target A to target B can be obtained by
using EBL/VRM knob.
3 Pressing ENT key (while pressing OFF key) returns CURSOR to the own ship position. Therefore,
it is possible to measure the distance/bearing from the own ship position.
4 Press EBL2 or VRM2 key displayed symbol, ERBL lines and values are not displayed.
ERBL R
000.0
°
1.000NM
ERBL
CURSOR
Target B
Target A
OFF
OFF key
ENT
ENT key
ERBL R
304.2
°
2.806NM
Own ship
ERBL R
304.2
°
2.806NM
Under bearing change
Under distance change