Owner manual

Kofax Export Connector 8.0.0 for IBM FileNet Image Services Administrator's Guide
11
Chapter 2
Installing the Export Connector
You can install the export connector on a client or standalone workstation. If you have an
existing version of this export connector, you must remove it before installing this version.
Important To install the export connector, you must have Windows administrator privileges.
If you do not have administrator privileges and install this export connector, error messages
may occur.
Before you install the export connector, refer to System Requirements for information about
installation requirements.
1
If you have installed an earlier version of the export connector, remove it.
2
On the installation media, locate and run Setup.msi.
3
Follow the instructions on the screen to install the export connector.
The installation wizard appears.
4
Click Next and follow the instructions on the screen to install the export connector.
5
Repeat the installation procedure on all Administration or Export workstations where
you plan to use the export connector.
The export connector is automatically registered with Kofax Capture or Kofax Express.
Note If you plan to use Kofax Capture and Kofax Express on the same workstation, see
the Kofax Express Installation Guide for more information.
6
Configure settings for the export connector. See Export Connector Setup.
Removing the Export Connector
Use the following procedures to remove the export connector from Kofax Capture or Kofax
Express and from your computer.
Removing the Export Connector from Kofax Capture
Removing the Export Connector from a Batch Class
1
In the Kofax Capture Administration module, on the Batch tab, expand the batch class to
view associated document classes.
2
Right-click the applicable document class, and select Export Connectors.
3
On the Assigned Export Connectors list, select the export connector and click Remove.