User`s guide

Scanner Configuration Utility
VirtualReScan (VRS) User’s Guide
123
Figure A-4. Create Source Dialog Box
6 Source name: Enter the name that will be used to reference the scanner or
source device from your scanning application. You can assign any name, if it
fits within the naming conventions of your application. Typically, the source
name corresponds to the name of the scanner or source device, along with a
description of the source type. An example source name might be “Scanner A
with ISIS,” where “Scanner A” corresponds to the make and model of the
scanner.
7 Source type: Select a source type from the list. The items on the source type
list correlate to the type of driver (ISIS, TWAIN, or Kofax) that supports your
scanner, as well as the software (VRS, AIPE, etc.) that you will be using with
the scanner. For example, if the selected scanner has an ISIS driver associated
with it, you will only see the scan sources (including VRS sources) associated
with ISIS scanning on the list. Select the type that is appropriate for your
installation. For more information, refer to Standard VRS Source Types on
page 131.
8 For information about the options in the “Image formatting” group, click
Help from the dialog box. Usually, it is not necessary to use these settings
unless you are instructed to do so by Kofax Technical Support.
9 Click OK to close the Create Source dialog box.
10 The Configure Sources dialog box will be displayed with the new source
added to the “Configured sources” list as the default selection. The newly
created source will now be available from your scanning application.