User Guide
Table Of Contents
- VirtualReScan 3.5 User’s Manual
- Contents
- How to Use This Guide
- Overview
- Operating VRS
- Introduction
- Scanning with VRS Default Settings
- Kofax VRS Scan Interfaces
- Configuring VRS Before You Scan
- Using VRS While You Scan
- VRS Advanced Properties Dialog Box Overview
- VRS Restore Default Values Utility
- Long Paper Support
- VRS Non-Interactive Mode
- Enhanced Bar Code Engine
- Patch Code Recognition
- Advanced Color Processing
- Index
Appendix F
96 VRS User’s Manual
Using the Color Tab
Use the procedure in this section to specify values for Automatic Color Detection,
Color Background Saturation, and Color Selection.
X To configure the Color tab settings
1 From the VRS Interactive Properties dialog box, select the Color tab.
Figure F-1. Color Tab
2 Select the Enable check box if you want to enable Automatic Color Detection.
If this check box is not selected, a color image is always returned when you
scan in color mode, regardless of the color content of the document.
3 Adjust the Color Content Aggressiveness setting by doing one of the
following:
• Move the slider to the left to decrease the likelihood of detecting a color
document.
• Move the slider to the right to increase the likelihood of detecting a color
document.
• Click the arrows of the text box to increase or decrease the Color Content
Aggressiveness value.