User Guide
Table Of Contents
- VirtualReScan 3.5 User’s Manual
- Contents
- How to Use This Guide
- Overview
- Operating VRS
- Introduction
- Scanning with VRS Default Settings
- Kofax VRS Scan Interfaces
- Configuring VRS Before You Scan
- Using VRS While You Scan
- VRS Advanced Properties Dialog Box Overview
- VRS Restore Default Values Utility
- Long Paper Support
- VRS Non-Interactive Mode
- Enhanced Bar Code Engine
- Patch Code Recognition
- Advanced Color Processing
- Index
Appendix F
100 VRS User’s Manual
Color Information on the Analysis Tab
When using the VRS advanced color processing features, you will notice that a group
box called Color Information appears on the Analysis tab. The two Color Information
values relate to the current image in the VRS Viewer:
• Detected Color: This value indicates whether or not the current image has
been processed as a color image or a bitonal image. To make the
determination, VRS takes into account the values on the Color tab in the VRS
Interactive Properties dialog box. Based on those settings and the amount of
color on the image, VRS determines whether or not the image is color or
bitonal.
• Color Confidence: This value indicates how certain VRS is about reporting the
content of an image as either color or bitonal. The Color Confidence value is
directly affected by the Color tab settings, including the color detection
aggressiveness settings.
You can review the values in the Color Information group box to help identify the
proper threshold value for color confidence on the Warnings tab, as well as the proper
settings on the Color tab. For more information, refer to Color Confidence Out of Range
Warning on page 99 or Using the Color Tab on page 96.