User Guide
Table Of Contents
- VirtualReScan 3.5 User’s Manual
- Contents
- How to Use This Guide
- Overview
- Operating VRS
- Introduction
- Scanning with VRS Default Settings
- Kofax VRS Scan Interfaces
- Configuring VRS Before You Scan
- Using VRS While You Scan
- VRS Advanced Properties Dialog Box Overview
- VRS Restore Default Values Utility
- Long Paper Support
- VRS Non-Interactive Mode
- Enhanced Bar Code Engine
- Patch Code Recognition
- Advanced Color Processing
- Index
Operating VRS
VRS User’s Manual
9
Note The profiles that you create from the Kofax VRS TWAIN interface are different
from the profiles created from the Profile tab of the VRS Interactive Properties dialog
box.
The General group consists of the following options:
• Source (Paper Source) – Select between the available input paper sources:
Flatbed or ADF.
• Resolution (DPI) – Select an option for scan resolution or DPI (dots per inch).
• Color Mode – Select from the color modes supported by the scanner, which
may include Black/White, Grayscale, or RGB (color).
• Paper Size – Select a paper size, such as Letter, A5, etc.
• Orientation – Select the paper orientation (portrait/landscape).
• Simplex/Duplex – Select single-sided or double-sided scanning.
A Preview check box, located in the lower left corner of the interface, allows you to
not only view the image as it is being scanned, but also to make changes to the image
in real time using the VRS Interactive Properties dialog box.
You can select the About button to view installation location and version information.
Figure 2-6. Kofax TWAIN Interface - About Dialog Box
X To scan using the Kofax VRS TWAIN interface
1 Open your scan application.
2 Select the Kofax VRS TWAIN scan source and click OK.