User Guide
Table Of Contents
- VirtualReScan 3.5 User’s Manual
- Contents
- How to Use This Guide
- Overview
- Operating VRS
- Introduction
- Scanning with VRS Default Settings
- Kofax VRS Scan Interfaces
- Configuring VRS Before You Scan
- Using VRS While You Scan
- VRS Advanced Properties Dialog Box Overview
- VRS Restore Default Values Utility
- Long Paper Support
- VRS Non-Interactive Mode
- Enhanced Bar Code Engine
- Patch Code Recognition
- Advanced Color Processing
- Index
Chapter 2
12 VRS User’s Manual
• Resolution (DPI) – Select an option for scan resolution or DPI (dots per inch).
• Color Mode – Select from the color modes supported by the scanner, which
may include Black/White, Grayscale, or RGB (color).
• Paper Size – Select a paper size, such as Letter, A5, etc.
• Orientation – Select the paper orientation (portrait/landscape).
• Simplex/Duplex – Select single-sided or double-sided scanning.
For situations in which you want to adjust image settings, you can access the VRS
Interactive Properties dialog box by clicking on the Advanced button. An option to
detect the page size being scanned is available by selecting Options | Special
Features, and then selecting the Detect Page Length check box from the Advanced
Settings dialog box.
Figure 2-10. Kofax VRS ISIS Interface - Advanced Settings Dialog Box
And finally, you can select the About button to open the About dialog box where
installation location and version information is listed.