User Guide
Table Of Contents
- VirtualReScan 3.5 User’s Manual
- Contents
- How to Use This Guide
- Overview
- Operating VRS
- Introduction
- Scanning with VRS Default Settings
- Kofax VRS Scan Interfaces
- Configuring VRS Before You Scan
- Using VRS While You Scan
- VRS Advanced Properties Dialog Box Overview
- VRS Restore Default Values Utility
- Long Paper Support
- VRS Non-Interactive Mode
- Enhanced Bar Code Engine
- Patch Code Recognition
- Advanced Color Processing
- Index
Chapter 2
34 VRS User’s Manual
Updating Image Properties
The VRS Interactive Properties dialog box consists of seven tabs, including three with
options for dynamically adjusting image properties as you scan.
Note If your scanning application is set to color mode and you are using VRS with a
Böwe Bell + Howell Spectrum II series scanner, an additional tab called Color appears
on this dialog box. For more information, refer to Advanced Color Processing on
page 93.
Figure 2-28. VRS Interactive Properties Dialog Box
When the dialog box opens for an exception condition, the status line lists the specific
cause for the warning or error. Otherwise, you see Status OK on the status line.