User Guide
Table Of Contents
- VirtualReScan 3.5 User’s Manual
- Contents
- How to Use This Guide
- Overview
- Operating VRS
- Introduction
- Scanning with VRS Default Settings
- Kofax VRS Scan Interfaces
- Configuring VRS Before You Scan
- Using VRS While You Scan
- VRS Advanced Properties Dialog Box Overview
- VRS Restore Default Values Utility
- Long Paper Support
- VRS Non-Interactive Mode
- Enhanced Bar Code Engine
- Patch Code Recognition
- Advanced Color Processing
- Index
Chapter 2
62 VRS User’s Manual
VRS Advanced Properties Dialog Box Overview
Users of the Böwe Bell + Howell Spectrum series, the Fujitsu fi-4990C, and the Fujitsu
fi-4860C have access to the VRS Advanced Properties dialog box via the Special
Features button on the Options tab. The Advanced Properties dialog box is made up
of the following tabs: Endorser, Color, Picking Rectangle, Rotation, and About. Each
tab is described in this section.
Figure 2-47. Advanced Properties Dialog Box
Some settings from the VRS Interactive Properties dialog box take precedence over
settings on the Advanced Properties dialog box tabs. Image processing tasks will
occur in this order:
1 VRS Interactive Properties Deskew (if enabled)
2 VRS Interactive Properties Auto Crop (if enabled)
3 Settings from the Advanced Properties Picking Rectangle tab
4 Settings from the Advanced Properties Rotation tab
Endorser Tab
VRS supports basic endorsing and annotation. For VRS Production-class scanners
that are equipped with endorsers, you can set up endorsing properties using the
Endorser tab of the Advanced Properties dialog box. Through the Endorser tab, you