User Guide

Table Of Contents
Appendix A
78 VRS User’s Manual
Changing the Default VRS Scanner
If you have used VRS with one scanner, but have switched to another scanner (or
scanners) at some point by reinstalling VRS, you may use the VRS Restore Default
Values Utility to change the default VRS scanner without reinstalling VRS again.
X To select another scanner as the default VRS scanner
1 Click twice on the RDV desktop icon to launch the utility.
2 On the Select scanner drop-down list in the VRS Scanner group, select the
scanner.
3 Click Apply. As a result, when Kofax VRS is listed as a source in your scan
application, this scanner will be used.
4 Click OK to close the utility.
If you are switching to a Canon DR-2080C, a Canon DR-3060, a Canon DR-3080C, a
Kodak i50, or a Kodak i60 scanner, you may receive an error message similar to the
following when you attempt to use the default scanner:
"Missing or Corrupt
ISIS.pxw scanner driver file."
This file is only installed by VRS when the scanner is
selected during the setup process.
X To install the ISIS.pxw (ISIS driver), do one of the following:
Install the ISIS driver from the scanner manufacturer CD.
Reinstall VRS and select the scanner during VRS setup.
If you are switching to a Canon CanoScan N 650U/N 656U, a Canon CanoScan
N 1220U, a Fujitsu fi-4110CU, an HP ScanJet 7400C series, or a Visioneer 9650 USB
scanner, please see the special TWAIN and/or USB installation instructions in
Chapter 2 of the VRS Installation Guide. Once you have installed the scanner using
these instructions, you will be able to use the VRS RDV utility to switch between
another scanner to this one and vice versa.