User Guide
Table Of Contents
- VirtualReScan 3.5 User’s Manual
- Contents
- How to Use This Guide
- Overview
- Operating VRS
- Introduction
- Scanning with VRS Default Settings
- Kofax VRS Scan Interfaces
- Configuring VRS Before You Scan
- Using VRS While You Scan
- VRS Advanced Properties Dialog Box Overview
- VRS Restore Default Values Utility
- Long Paper Support
- VRS Non-Interactive Mode
- Enhanced Bar Code Engine
- Patch Code Recognition
- Advanced Color Processing
- Index

VRS User’s Manual 81
Appendix C
VRS Non-Interactive Mode
Using Non-Interactive Mode vs. Interactive Mode
Users of the Böwe Bell + Howell Spectrum series scanners have the choice of selecting
VRS in a non-interactive mode at the time of installation. This mode is specifically
designed for Böwe Bell + Howell users who do not wish to see any VRS dialog boxes
while scanning, even though VRS is running conveniently in the background.
While this feature is automatically set during installation of a Böwe Bell + Howell
Spectrum II series scanner, VRS non-interactive mode can be switched back to
interactive mode.
X To switch the Böwe Bell + Howell Spectrum series scanner from non-
interactive mode to interactive mode
1 Right-click on the VRS taskbar icon.
2 Select QC Modes | Hardware Warnings.
3 Select On Errors. Non-interactive mode will effectively be turned off.
4 In addition, you may go to the VRS Administration Utility and customize
how you want VRS to respond to hardware problems. Refer to Configuring
VRS Before You Scan on page 15 for more information.