User Guide
Table Of Contents
- VirtualReScan 3.5 User’s Manual
- Contents
- How to Use This Guide
- Overview
- Operating VRS
- Introduction
- Scanning with VRS Default Settings
- Kofax VRS Scan Interfaces
- Configuring VRS Before You Scan
- Using VRS While You Scan
- VRS Advanced Properties Dialog Box Overview
- VRS Restore Default Values Utility
- Long Paper Support
- VRS Non-Interactive Mode
- Enhanced Bar Code Engine
- Patch Code Recognition
- Advanced Color Processing
- Index
Enhanced Bar Code Engine
VRS User’s Manual
85
Standard bar codes include the following:
• Codabar
• Code 128
• Code 39 (3 of 9)
•Code 93
•EAN
• Interleaved 2 of 5
• Linear 2 of 5
•Postnet
•UPC-A
•UPC-E
How to Switch Between Bar Code Engines
While the Kofax Enhanced Bar Code recognition engine offers many advantages over
the standard bar code recognition engines, in some cases the processing speed may
vary. For those who wish to focus on processing speed rather than quality of
recognition, the Standard Algorithm may be preferable. To make this transition
easier, both algorithms are available for selection at any time without restarting the
scan application.
X To switch the active bar code engine
1 At the Bar Code Properties dialog box, go to the Bar Code Algorithm group.
2 Select one of the following check boxes:
• Standard Bar Codes
• Enhanced Bar Codes
3 The corresponding bar code types will immediately become available.
4 Select the desired bar code type(s). Hold down the Control key to select
multiple bar codes.
5 Click OK.
Note The 2D bar codes are not supported when you switch to the Standard
Bar Code algorithm.