Download

7
SELECTING A SUITABLE LOCATION
When selecting a position for your unit, ensure the floor is flat and firm, and
the room is well ventilated. Avoid placing your unit near a heat source (ie,
oven, radiator, or hot water system). Avoid direct sunlight as it may increase
the electrical consumption. Extreme cold temperatures may also cause the
unit to not perform correctly. This unit is not designed for use in a garage or
outdoors. Do not drape the unit with any covering.
When installing the unit, ensure that 10cm of free space is allowed to the
left, right and rear of the unit, and 30cm at the top. This will allow cold air to
circulate around the unit and improve the efficiency of the cooling process.
1a. Door space requirements
The unit’s door must be able to open fully as
pictured (1a).
1b. Levelling the unit
To level the unit, adjust the two feet at the front
of the unit – turning clockwise to extend and
counter-clockwise to reduce. If the unit is not level,
the door and magnetic seal alignments will not
be covered properly, leading to inefficient freezing
performance (1b). Ensure that the feet all touch
the ground before use.
Figure 1a
Figure 1b
INSTALLATION