Download

When there is no power to
the juicer
• Check if the power cord is properly plugged in.
• Check if the drum lid and the juicing bowl are
properly assembled.
• Ensure that the topset and base of the juicer have
been assembled correctly, following the step by step
instructions in the Assembly portion of this guide.
• Juicer will not operate if parts are not assembled
properly.
Low juice yield
• Different ingredients hold different amounts of fluid
that will yield different amounts of juice.
• If the ingredients are not fresh, they may contain
reduced amounts of fluid, which will yield less juice.
• Check if the compression silicone is firmly inserted.
• If the ingredient itself has low water content, soak it in
water before juicing.
• If juicing ingredients with small seeds, after few
servings, it may reduce the juice yield. For best results
,
disassemble and wash the topset in between juicing.
• If there is seed residue on the bottom of the strainer,
this can affect juicer performance and the overall
juice yield.
There is too much pulp in
the juice
• When continuously juicing and depending on the
ingredient, the juice may contain a lot of fine pulp.
• To reduce the fine pulp, clean the topset frequently
and extract the pulp.
• Use a mesh strainer and put the juice through it to
collect the unwanted pulp.
• If the strainer and the screw are damaged and
affecting the juicer’s performance, it is recommended
to replace the parts.
• The lifetime of each part may vary depending on
length and method of use and ingredients extracted.
• If too many ingredients are inserted at the same time,
it may cause the juicer to stop frequently. This can
lead to pulpy juice, insert the ingredients slowly and
few at a time.
TROUBLESHOOTING