Table of Contents General Safety Warnings............................................................................................................................................ 2 Technical Specifications.............................................................................................................................................. 2 Product Layout.................................................................................................................................................
General Safety Warnings • • • • • • • • • • • • • • • • • • • • • • • • Read all instructions carefully before use. Make sure the voltage supplied matches the requirements indicated on the rating plate of the heater. Do not operate this appliance if the cable or plug has become damaged. Keep the appliance and cable away from other sources of heat, sharp objects or anything else that may cause damage. If the cord is damaged, it must be replaced by Kogan.com in order to avoid a hazard.
Product Layout 1 2 3 1. Decorative Glass 4 2. LCD Screen (blank when OFF) 3. Operation Buttons 5 4. Feet 6 5. Rear Cover 7 6. Power ON/OFF Switch 8 7. Power Cable 8. Sensor 9. Remote Controller 9 Assembly Free Standing 1. Attach the two plastic feet to the bottom, then fix with the provided screws with the help of a screwdriver. Each foot should be secured with 4 screws. 2. Be sure to place the heater on a flat, stable surface.
Installing and Fixing the Heater 1. Take out the wall brackets and expansion screws from the box, then fix the screws onto the wall according to the distances between the holes of the wall brackets, as shown in the image below. Hook Expansion Screw Hook Expansion Screw 2. Aim the 4 holes in the back of the heater to the 4 hooks on the wall bracket and push it on, then slide them into the slots to click on, as shown in the image below. 3.
Operation 1. Connect the heater to a power socket, then switch the ON/OFF switch on the side panel. 2. Press the buttons on the operation panel or remote control to set the heating. Setting Mode O OFF (Stop) I 1000W II 2000W 3. Press the button on the heater, and the machine will go into Standby Mode and Frost-Free mode. Press the power button “ ” to set to ECO mode, with displaying at Economic I power, or alternately “ ” displaying at Comfort II power, or Frost-free mode “ ”.
Maintenance 1. Always disconnect the heater and let it cool down completely before any maintenance. 2. Use a vacuum cleaner to remove dust and fluff from the grilles. 3. Clean the outside of the unit with a soft damp cloth, then dry it with a dry cloth. Never immerse the unit in water, nor let water drip into the unit. Overheating Safety Device The heater is fitted with a safety device to switch it off in the event of overheating.