Installation Sheet

Installation Guide SKU#23660, SKU#23662
USA/Canada: 1-800-4 KOHLER 1412009_2
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
5. Your product may appear different than the one illustrated. The installation procedures remain the same.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto a clean
and soft cloth to protect finish. Confirm all parts are included.
2. Remove mounting plate (B) from canopy (E).
3. Thread wire through rod (J), (I), (H), (G), (F), canopy (E) and joint ball (D).
Install all the parts onto the fixture (N).
4. Install shades (M), cages (K) onto fixture with socket rings (L).
5. Trim excess wires to minimum 6” beyond canopy (E), strip wires to 5/8” at
end of wire and twist.
6. Attach mounting plate (B) onto outlet box with screws (C). Ensure the
direction of ground screw (P) is as shown.
7. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture green or bare ground wires to the green or bare copper wire in
outlet box with wire nut (A) or fasten onto ground screw (P) on mounting
plate.
8. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture white wires to the white wire in outlet box with wire nut (A). Wrap
the wire connector with electrical tape so that the tape seals the end of
wire nut (A), see diagram.
9. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture lead wire without ridge(s) or black wire to the black wire in outlet
box with wire nut (A). Wrap the wire connector with electrical tape so that
the tape seals the end of wire nut (A), see diagram.
10. Tuck wires carefully inside outlet box. Attach the canopy (E) onto mounting
plate (B) and secure it with screws (O).
11. NOTICE: Do not exceed recommended wattage. Install lamp(s).
Rated Max 60 W, Type G16.5. (Bulb(s) not included).
12. Restore power to circuit at breaker or fuse box.
CLEANING
Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild soap.
A
B
C
D
O
E
F
G
H
P
I
J
K
L
N
M
Approved fastener
(Wire nut)
Electrical tape
Phillips & Flathead
Screwdriver
Slip Joint
Pliers
Small Adjustable
Wrench
Wire
Cutter/stripper
Electrical
Current Tester
Electrical
Tape